|
|
Post by ruppluver on Aug 10, 2008 13:00:51 GMT -6
Can I install a Mukuni carb on the wide carb mount on an American 440? Center to center on bolts is 3". Also,can I take a 340,which doesn't have CDI and put it on a sled that HAD CDI? I'll be using the wiring harness that hooked into CDI. Thanks.
|
|
|
|
Post by wigman25 on Aug 10, 2008 20:13:43 GMT -6
Sure, you just need to get the proper manifold mounting flange for the mikuni and the carb should clamp right on. Don't know about the CDI/points swap, one of the other guys can probably help you with that. Good luck with the project - POST SOME PICS! Wig
|
|
magnumforce
Administrator'
{S=0}
NEW EMAIL ADRESS:ruppster@ymail.com Microsoft took away my hotmail account after 12 years, so....
Posts: 1,423
|
Post by magnumforce on Aug 12, 2008 1:17:46 GMT -6
Hi ruppluver . You can install a points motor in a cdi chassis there is one more ground/kill wire on the CDI if I remember correct.you need to ground the stator into the orig kill wire from the orig cdi box wire, otherwise when you shut it off only one side quits firing... a TR440 carb swap works, good starting point with a 34mm Mikuni.........this is @ 1100' above sea level.............................................................................. 260 main jet 40 pilot jet 2.0-2.5 slide valve 6DH-4 jet needle (clip 2nd or 3rd from top) Q-O jet needle Air screw 1 & 1/4 turns out An 'S' Nitro motor may require a 270 or 280 main  |
|
